Former New York State Senator and Homeland Security advisor Michael Balboni broke down the chilling details of the attack that killed conservative activist C...
Absolutely, any home made pistol would have some teething issues. I have an 80% “glock” that took a while to make reliable. I think I had to put about 800rds through it as well as replacing the extractor with an aftermarket machined one instead of the shitty imperfect OEM one and doing a little bit of polishing on the internal hardware before it could get through a whole magazine without a failure. I would have been dumb as a rock to carry that for protection before I had another 500-1000rds down the pipe without a single malfunction.
Don’t those 3d printed guns usually start malfunctioning as a result of moderate use, as in the process of testing then?
Absolutely, any home made pistol would have some teething issues. I have an 80% “glock” that took a while to make reliable. I think I had to put about 800rds through it as well as replacing the extractor with an aftermarket machined one instead of the shitty imperfect OEM one and doing a little bit of polishing on the internal hardware before it could get through a whole magazine without a failure. I would have been dumb as a rock to carry that for protection before I had another 500-1000rds down the pipe without a single malfunction.